Again, this post covers the past couple of days…

Here’s the right wing top with its first round of white epoxy primer.

And another shot from the finished (primer wise) winglet side.

On the left wing I hit it too with a coat of white epoxy primer.

Also a shot from the winglet end of the left wing.

I also shot the outboard sides of the rudder and the left strake hatch door with white primer as well.

After a good while (maybe even the next day?) I filled the depression on the top of the left wing where I repaired the delam.  I’ll do a final coat on that when I flip the wing back upright… see below.

I also gave the aft nose/avionics cover a thorough sanding as well.

Jess helped me flip left wing inverted onto the elevated wing dolly (that’s on it’s last leg).  I then shot the bottom of the left wing with gray epoxy primer, and at some point during the day we got a quick rain shower before the sun came back out… thus all the gray water spots.

Before I sanded down the gray epoxy primer I filled all the pin holes, low spots and scratches with Icing filler.

Tomorrow I’ll sand the bottom of the left wing and hit it with its first coat of white epoxy primer.

Nugging through this primer/painting!