Chapter 23 – Cable Bracket installed

Today I finalized the install of the throttle(s) and mixture cable bracket by laying up 2 plies of BID on all sides of the initially installed bracket.

I then peel plied the layups on the throttle(s) and mixture bracket.

After some clean-up, minor tweaking, drilling and thread-tapping on the new throttle handle lever, I also did a fair amount of CAD work polishing the 3D printed throttle handle cable guide components.

I also worked on editing the video but didn’t get nearly as far as I wanted to on it.  I really honestly should have it finished tomorrow.

Pushing forward!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.