Chapter 3 – Tooling up: Mistress Build

Happy Cinco De Mayo everyone!

Just wanted to do a quick post showing the new Voron 2.4 3D printer is operationally complete and kicking out parts.  Moreover, my back is back and I am operational as well!

Here is the first print (in PLA) on the Voron 2.4:

I then did a few other torture test prints before kicking this one off.  Normally this would have been nearly a 2-day print on Bob or Sally, but on the Voron it took about 11 hours.

A few days later I had the new Voron 2.4 dialed in even more and started printing no kidding ABS parts… as advertised, this thing is a BEAST!

Just one final shot of my newly built and operational Voron 2.4 3D printer.  I’ll stop boring you guys with non-airplane building stuff (although very related & critical for my plane build).  Also wanted to let you all know what I was up to while down for the count with my back being thrown out!

That being said, with Mother’s Day and Jess’s birthday coming up over the next couple of weeks, I’ll again be offline from the plane build (I have some house repairs that really need to get done as well) for a good 2-3 weeks.

But I’ll be back to it ASAP!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.